Water Watch - Electronic Urinal Flush Control Systems

installation | specification | pdf downloads

Water Watch Installation & Specification

Installation could not be easier.

The complete system comprises a combined sensor and control unit positioned at high level to detect occupancy and a solenoid valve installed on the cistern supply.

A 3 amp, 2 core flex connects the two units.

Simple switches to set control parameters, makes commissioning quick and easy.

Full installation and commissioning instructions are included with each unit.

Specifications

Sensor Unit

Dimensions: 125 x 80 x 35mm
Construction: Vandal resistant steel
Colour: White enamel finish

Programme

Flush rate: 1,2,3 or 4 Flushes/ Hour
Hygiene cycle: 12 or 24 hours selectable.
Time measurement: Quartz crystal clock

Movement Detector

Type: PIR (Passive Infra Red)
Range (Maximum): 5 metres.
Lens: Multizone Fresnel
Indicator: Flashing red LED

Battery Power Supply

Battery: 4.5V, 5.4 Ah Long Life Duracell
Battery low indicator: Flashing red LED
Battery life: 3 + years

Mains Power Supply

Voltage: 240V AC, 50 Hz
Power consumption: 1.8 Watts
Connection: 1A un-switched fuse spur from 24 hour supply

Water Supply Valve

Solenoid valve: 9 Volt latching UK WFBS approved.
Operating pressure: 0.1-10 Bar
Integral water filter: Stainless steel, replaceable
Fittings: 15 mm compression

Water Audit

Interface: 300 Bits/s serial data
Audit data:

Total flushes, hygiene flushes, programmed settings, operational hours.

PDF downloads

	Water Watch Brochure
	Water Watch Installation Instructions

	Water Watch Operating Instructions
	Water Watch Auditor

To view these documents you will need Adobe PDF reader installed on your PC, click here to download and install the latest version now.

Homepage

Biofresh

Prices / ordering

Mesh Communications Limited
21 Ashwood
Bowdon
Altrincham
Cheshire
WA14 3DN

Phone: 0161 929 7844
(Outside UK) +44 161 929 7844
Fax: 0870 005 2772
Email: